| Caratteristiche
Tecniche |
| Size
(WxHxD) |
340mm
x 405mm x 340mm (13.5" x 16" x 13.5")
|
| Weight |
22
kgs (48.5 lbs) |
| Drivers |
Bass:
200 mm (8 in)
HF: soft dome 28mm (1.125in) |
| Maximum
SPL |
LCR
108dB(C) |
| Frequency
Response |
55Hz
- 18kHz +/-2dB |
| Input |
|
| Connector: |
XLR3
Female |
| Impedance: |
10
kohm. Electronically balanced RF filtered |
| Wiring: |
Pin
1 Ground, Pin 2 Hot, Pin 3 Cold |
| Sensitivity: |
Rear
switch to select:
-18dBu to 0dBu in 2dB steps for 100dB SPL
Max input for clip +20dBu at 5kHz on 0dBu setting |
| Filters |
|
| Subsonic: |
-3dB
at 27Hz, 12dB/oct (LF equaliser out). |
| RF: |
-3dB
at 250Hz, 6dB/oct (HF equaliser out). |
| Crossover: |
1.25kHz,
24dB/oct. |
| User
LF EQ: |
3
position rear switch to select OFF for normal use (nominally
flat), EXTENDED for nominal +1dB lift below 55 Hz, and OUT
for use with an external sub-woofer. |
| User
HF EQ: |
3
position rear switch to select OFF for normal use (nominally
flat), LIFT for nominal +1dB from 5kHz and CUT -1dB from
6kHz. |
| Power
Amplifer |
|
| LF
output power: |
>110W
rms continuous.* |
| HF
output power: |
>100W
rms continuous.* |
| |
*
The continuous rating is for a period not exceeding 5 minutes
with unrestricted airflow (100mm clearance) around the amplifier
heatsinks and ambient temperature is < 30°C. |
| T.H.D. |
<0.03%
at levels up to 1dB below clip, 20Hz - 20kHz typ. 0.005%
at 20W rms 1kHz. |
| Hum
+ Noise |
>-100dB
referred to clip |
| Indication |
|
| Power
on |
Front
mounted LED (green) indicates power applied |
| Overload |
Front
mounted LED (flashes red) indicates 0.5dB below signal clip. |
| Thermal
protection |
Front
mounted LED turns red, signal is muted and amplifier switches
to standby mode during thermal protection cooling cycle.
Normal operation resumes when heatsink temperature drops
by 20°C. |
| Power
requirements |
|
| Voltage |
Set
by internal plug: nominal 115V or 230V at 50 - 60Hz AC.
230V setting: Min 160V (restricted output power): Max 263V
115V setting: Min 80V (restricted output power): Max 132V |
| Consumption |
Quiscent:
55W. Typical use: 130W. Max: 415W. |
| Note: |
0dBv
= 775mV into open circuit. |
|
